MANAGEMENT MODEL FOR CONSTRUCTION WASTE PRODUCED IN THE CITY OF RIO DE JANEIRO
Background: A new management model for construction and demolition waste (CDW) was proposed for the city of Rio de Janeiro, hence waste the city planning area estimated generation; the results were compared with the data published by COMLURB and SNIS through the statistics tests was proved that CDW had been dispersed, which support the hypothesis that the current model cause dispersion of the rubble. Aim: This study proposes a new management model for CDW to the city, according to regions where occur the higher production of rubble. Methods: The estimation of rubble was obtained through the issued licenses from 2006 to 2020 published by SMPU. The quantification of rubble in the city was carried out by adopting the generation indicator from licensed construction activities. The amount of CDW published by COMLURB and SNIS was compared through statistics tests ANOVA and T-Test, the second period from 2006 to 2020 and 2011 to 2020. To measure the area to implant a CDW recycling plant, criteria from production capacity were used. Results: ANOVA test to data from 2006 to 2020 and 2011 to 2020, according to a confidence interval of 95%, found the P value 0.589 and 0.022, respectively, it was verified that the significant difference is between data from COMLURB and Estimated. The T-test was applied from the same period in data from SNIS and estimated the P values 0.399 and 0.014. Discussion: The data from Estimating between 2006 and 2020 showed the best representation. The Área de Planejamento – AP (Planning Area) 4 was where 50.70% of the total rubble, after the AP 3 with 17.66%, the AP 5 was estimated at 16.59%, last of all, AP 2 and AP 1 were calculated the generation of 8.28% and 6.77%, respectively. Therefore, sizing the CDW recycling producing 361,99.00 tons per year demands an area of 32,397.50 m². Conclusions: It was concluded that the receipt of CDW in transfer stations managed by COMLURB is not allowed; therefore, the need to create a construction waste recycling plant was presented, to this end, it is necessary to have an available area of approximately 32,397.50 m².
Read ArticleSLOW PYROLYSIS OF RICE STRAW: ANALYSIS OF BIOCHAR, BIO-OIL AND GAS
Biomass is the term attributed to any renewable resource derived from organic matter that can be used in energy production. Agricultural production generates residues that are of great importance for their energy use, of which sugar cane, eucalyptus, and rice. Various residues are generated from rice cultivation, among which the rice husk and rice straw are the most important. Several thermal conversion technologies have been developed for the use of biomass in industry. Pyrolysis has been notable for its ability to produce biofuels at different stages of aggregation. The slow pyrolysis of biomass has been proposed as a pretreatment method to improve the physical-chemical characteristics of rice straw. In this process is produced, mainly, a solid called biochar, which has a higher energy content when compared to the biomass of origin. This study investigated the slow pyrolysis of rice straw at 300 - 700°C for the purpose of obtaining biochar, bio-oil, and gases for energy purposes. The experimental results show that pyrolysis temperature has important roles in yield product. The highest biochar yield was observed at a temperature of 300°C with 49.91 wt%. This represents 47% more when compared to yield at 700°C (33.87 wt.%). This behavior is linked to the proximate analysis results for fixed carbon 26.01 wt.% at 300°C. The high pH of the biochar was attributed to the presence of alkali metals, according to XRF. Thermal decomposition of the biomass resulting in a gradual increase of bio-oil (16.81 - 34.70 wt.%) and gas (6.53 - 18.05 wt.%) on a wet basis. Thus, in the dry base parameter, the bio-oil increases from 19.22 - 30.6 wt.% and the gases at 9.42-20.19 wt.%. Drying of the raw material showed, by the results, a significant increase in the co-products.
Read ArticleDENSE CLUSTERS OF RAW SEWAGE LOCATIONS ON MINNA NEIGHBOURHOOD GIS MAPS ARE POINTERS TO VERITABLE URBAN DECAY AND MOSQUITO-BREEDING GROUNDS
Background: The lack of comprehensive baseline data on raw sewage pollution in Minna, Nigeria's Niger State capital, represents a significant gap in public health information. This deficiency necessitates a systematic study to establish a database documenting sewage pollution patterns in Minna's urban environment. Aim: To employ georeferencing tools and descriptive observations for identifying and mapping potential mosquito breeding sites related to sewage discharge within Minna's built-up areas and to develop an interactive Geographic Information System (GIS) map as an environmental audit tool for public health officials. Methods: The study area was divided into five sectors: Greater Bosso, Minna Central, Greater Maitumbi, Tunga, and Greater Chanchaga. Following initial site familiarization and GIS equipment testing, systematic surveys were conducted. Field teams documented locations of household sewage discharge points, collecting geographic coordinates, temporal data (date, time, weather conditions), and site characteristics. Each identified location was photographed and recorded in standardized data sheets, including household information where available. Results: Using ArcGIS®10.8 software, comprehensive sewage pollution layers were created for each sector by integrating collected field data with Minna's township built-up and settlement shapefiles. The mapping revealed distinct pollution patterns and clusters across different neighborhoods. Discussion: Analysis of the spatial distribution showed a clear correlation between socioeconomic status and sewage management practices, with higher concentrations of improper sewage discharge in low-income areas. Conclusions: This database serves as a valuable resource for public health interventions targeting mosquito breeding grounds. Regular monitoring through periodic sewage pollution audits and expanded geographical coverage is recommended for improved urban health management.
Read Article