SOUTHERN JOURNAL OF SCIENCES

Prescription and non-prescription medication misuse or abuse is a global problem that has a negative impact on all human life aspects, including health, social, economic, and security status. According to the United Nations Office on Drug and Crime reports, over 5% of adult people used drugs at least once in the year 2015, and 29.5 million of them were suffered from the consequences of inappropriate use of drugs. Information on the knowledge and perception among pharmacists regarding the misuse and abuse medications in Saudi Arabia are limited, and therefore, a study was conducted among pharmacy staff to assess their knowledge and awareness on drug misuse and abuse. A cross-sectional study was carried out in Eastern Province, Saudi Arabia. Pharmacy professionals with more than three months of experience were included in the study. A structured questionnaire was used to obtain the participant's responses. A Chi-square test was used to evaluate the association of sociodemographic factors with the participant's responses. Ninety pharmacy professionals were responded. Overall, 69 (76.7%) participants agreed that misuse and abuse are two different terms. In addition, the study showed different responses for patients who suspected to be medication abusers. In conclusion, this study provides an initial picture of pharmacy staffs' knowledge and opinion regarding the misuse and abuse of medicines in Saudi Arabia. Participants' reactions toward such behaviors were different and not consistent. Therefore, there should be a clear policy to define the role of the pharmacy staff toward the misuse and abuse of medication in Saudi Arabia.

Background: Due to population growth and increased use of water resources, there has been a need to implement management measures to control and monitor river parameters. Aims: This study aims to demonstrate the application of mathematical modeling using the QUAL-UFMG model for studying nitrogen concentration in the Paraíba do Sul River located in Volta Redonda. Methods: Through mathematical modeling, it is possible to identify areas of greater impact, evaluate the effectiveness of control measures, and propose a strategy to improve water quality and preserve the balance of local aquatic ecosystems. Results: The results obtained during the study showed that the nitrogen parameters and their derivatives are within the pre-established limits set by CONAMA. Discussion: During the modeling, it was observed that there is a tendency for nitrate levels to increase along the points, indicating good self-purification of the river. Organic nitrogen values increase along the points, which is due to the contribution of sewage discharge along the course of the river, as organic nitrogen and ammonia have a physiological origin in domestic sewage. Conclusions: Through the QUAL-UFMG model, it was possible to validate the conducted analyses and create future projections of the water quality in the Paraíba do Sul River along the studied points.

Background: MQ-series gas sensors belong to the metal oxide semiconductor (MOS) family of sensors that can sense the presence of many gases. These sensors find their application in gas alarm systems as key components. While necessary sensor circuit output voltage value for alarm point in a stand-alone gas alarm system is desirable, but what exact combination of the sensor circuit parameters is required? Hitherto, the determination of these circuit parameters has not been given much attention in the research community. Aim: the purpose of this work is to explore a structured graphical approach of determination of MQ series gas sensor circuit parameters for a stand-alone gas alarm system that yields desired sensor circuit output voltage value for the alarm point; the main objective of the study was to develop mathematical model equations that relate the: (i) sensor resistance (RS) with the gas concentration (x) and the sensor resistance at standard calibration concentration of the sensor base gas in the clean air (Ro) and (ii) sensor circuit output voltage (VRL), load resistance (RL) and sensor resistance (RS). It is expected from the model equations developed that graphical correlations of the sensor circuits parameters will be generated. Using these graphs for a particular case of an MQ-4 gas sensor under the influence of LPG, the parameters that yield desired sensor circuit output voltage of 2V for 1000 ppm of LPG alarm point will be determined. Methods: Model equations were developed for the sensor dynamics, and based on these model equations, graphs for the determination of required sensor parameters were plotted for a case of MQ-4 gas sensor response to LPG. Results and Discussion: The results yielded optimal values for R_O,R_S and R_L of 20 kΩ, 30 kΩ and 20 kΩ respectively, for alarm settings of 1000 ppm and a desired sensor circuit output voltage of 2 V. Based on determined parameters, the calibration equation for determination of best concentration value for a given value of emulated LPG concentration was developed. Using the method proposed in this study makes the process of determining the MQ-series gas sensor circuit parameters less cumbersome as their value can easily be obtained from the resulting graphs. Conclusions: a structured graphical approach for determination of MQ-series gas sensor circuit parameters for alarm points in a stand-alone gas alarm system showed that using MQ-4 gas sensor and LPG as the target gas, and for a sensor circuit output voltage of 2 V for alarm point at 1000 ppm of LPG, the corresponding value of R_O, R_S and R_L obtained were 20 kΩ, 30 kΩ, and 20 kΩ respectively. Hence, a structured graphical approach is suitable for determining MQ series gas sensor circuit parameters for a stand-alone gas alarm system under the influence of its associated gases.